How can I obtain an extruded wall face plate?

Question

I need a wall face plate, but not just flat like usual, rather extruded out from the wall about an inch.

The problem is that the hole in the wall is very small, and so the cable will bend before going into the hole, so I need a plate that will have enough space to allow that to happen.

I happen to need one that is Ethernet/coax duo, but any information about any type of plate matching the description would be helpful.

Answer 1

You can get the plate at hardware stores. Extend the box with something like this http://www.homecontrols.com/Arlington-Box-Extender-AABES1 They have them at hardware stores too.

Answer 2

Just get a shallow one-gang Wiremold box and mount it over the cable access, then use a standard flat plate on it with the jack arrangement you need. These are available in any hardware, building supply or electrical supply store. The backplate screws to the wall (after you knock out whichever opening you need for the cable in it) and then the cover box (similar to the "extrusion" you are describing) covers it with room for the cable and devices inside. I installed thousands of these when I was an installation electrician, especially when renovating old schools and offices with data jacks. Here is what it looks like.



http://www.legrand.us/wiremold/raceway/steel-raceway/single-channel-raceway/500-700-small-raceway/5748s-single-gang-shallow-switch-receptacle-box.aspx

Answer 3

Ceramic plates are thank you to high priced..... metallic plates arent that super yet are low-value and if used suited can stop a variety of bullets.... humorous you should ask this right now.... I took 3/16ths inch metallic plates to the gun variety right now and seven.62x39MM, 30/06 and .223 rifle cartridge bullets shrink via it like warm butter at one hundred yards... on the different hand .40 5 and 9MM pistol rounds weren't in a position to bypass via the metallic at 50 yards.... I wouldnt get to hung up on the grade of metallic.... What seems to artwork for me is layers of metallic... a pair of a million/4 inch metallic plates will stop maximum rifle bullets..... in one area of a house in a crappy community the owner had me placed a million/4 inch metallic plates and crammed something of the interior wall section up with layers of drywall 5 a million/2 inch thick..... you additionally can use metallic plates interior the wall framing and fill in between with sand.... be optimistic the residences shape can take the load..... I worked with this one guy that lived in a crappy community with low existence gang varieties taking photos up the area.... He placed a a million/2 inch thick metallic plate in the back of the settee the place he sat and watched television.... It develop into interior the front of the residing house and additionally develop into the main secure place to take a seat.... Bulletproofing a house could be authentic high priced - extra like wreck the bank... Have the fascade of the residing house coated in brick... or in basic terms bullet evidence basically the areas the place you sleep or watch television or the different section you spend a while it...