Oiling
Hardwood worktops must be thoroughly treated with protective Danish Oil, to all sides,
. An extra three to four coats should also be applied around tapholes, sink cutouts and areas of heavy use or exposure.
Oils are best applied by using a lint-free cloth rather than a brush. A lint-free cloth is any form of material that will not deposit any particles on the wood - an old T-shirt is usually ideal.
When applying the oil yourself, it is best to apply several thin coats rather than one thick application. Always work the oil into the worktop in the direction of the wood grain for best results.
After applying the first coat, you will probably notice that some areas are wet and others dry. This is because the wood will absorb the oil at different degrees in different areas. Wait for 15minutes and then run the cloth over the entire surface again to ensure an even spread. Do not allow large pools of oil to dry on the surface.
Apply the second and third coats in the same manner, allowing ½ hour -1hour for drying time in between coats.
If the surface feels slightly rough in certain areas, or if you wish to develop a smoother surface, then we recommend that you apply a further coat of oil using either a green nylon scouring sponge or wire wool.
Worktops can be finely sanded between coats (120grit - 180grit). However, work surfaces should never be sanded finer than 180grit. To do so will prevent any future applications of oil from penetrating the surface.
Cutting