Where do i start on re-roofing on bare structure?

Question

I bought a house nearly 3 years ago and the patio (normally just cement) had been covered but a half *** job. there was no metal sheet between the house and the cover which allowed rain to seep through. The ceiling was also done with what looked to be wall board instead of ply wood, so when the rain did come in it pretty much melted away the board. I am trying to do it all myself and the one and im guessing the most important thing is that the overall structure is still good. found that out when i was looking for estimates. the patio is about 300 sqft and i am wanting strip it all and redo the whole thing. does anyone have any good websites for steps or know where to start once all the materials have been bought?

Answer 1

Metal Roof?....http://www.bestbuymetals.com/pdf/standing-seam-installation-guide.pdf



End closures are worthwhile, it keeps out rain, birds, bees, squirrels, wasp, also "Dummy Tape" is important.



Notice "Transition Flashing" from house to patio, also notice sheet metal side don't hang over, they're flush , so that "Gable Flashing" touches boxing.

Answer 2

I am not aware of a web-site. But, if you go to one of your building supply centers they will have sel-help manuals you can buy on "additions". I can help you get started. Apply 1/2" treated roof sheathing (nailed to stringers). Allow for overhang for rain drip/gutter (6") on all 3 sides. Staple down 30lb. black rolled felt (overlap the sections 2" as you go). Install flashing weather barrier (8" wd) this is aluminum on a roll and get enough to go the width of roof. This is installed up and under your house gutter and curls down to your addition, nail down and caulk any gaps/nailheads, etc.Next, install drip edge all around the perimeter of new roof (the 3 sides). Next, install roof shingles and use 1/2"L galv. nails, overlap the rows enough to cover the nail heads and start at the bottom and work your way up. Snap a chalk line for better/accurate installation as you go using a tape measure and always start from the bottom edge of the roof. You stagger your shingles utilizing the drip grooves manufactured into them. Add your fascia with supports to box in your overhangs if you want to. Primecoat this part if you are not staining, then finish paint to suit.

Answer 3

i use to be an independent contractor for Lowe's,i strongly suggest you consult there,they have how to do it yourself books that you can buy,also they should have qualified techs. that can help you through it.if you have some common knowledge of construction,the how to book should do just fine,if you come upon something you are not sure of,then refer back to the store,they will be more then glad to help you,remember,thats what they are there for and get paid for as well..most important,take your time,watch the weather and keep bare wood materials covered and up off the ground (3-4 inches)in the event of rain.remember to get plywood clips when installing the plywood.they are well worth the extra money.hope this helps.